Specification and installation instructions for attachment eye

With captive, yet detachable hexagon head bolt that is 100% crack tested
Collapsible load ring, fully rotatable
Load ring must be configured against loads in the direction of force, must move freely and must not rest on edges
Only one tapped hole or clearance hole required, extremely small construction
Design the attachment point such that the introduced forces from the base material are absorbed without deformation
Screw-in material min. 1.0037 (St 37). For light metals, non-ferrous metals and grey cast iron, the thread assignment must be selected such that the thread load capacity meets the requirements for the respective base material
Ensure mounting surface is level; blind holes must be drilled deep enough so that the supporting surface can rest on top
If there is only one transport journey, it is sufficient to screw in and tighten by hand using an open-ended spanner
The attachment eye must be level without additional washers and lie fully on the mounting surface with a supporting surface (ØA)
If the attachment eye is to remain permanently on the load, it must be tightened by 30 Nm (+/- 10%)
It must be possible to rotate the screw bolt by 360° when tightened.
It may inadvertently loosen if there is transient stress, twisting or vibrations, particularly where there are straight couplings with nuts
Securing options: liquid thread securing agents such as Loctite
(Observe manufacturer’s guidelines) or a positive-locking screw lock such as a castellated nut with split pin, lock nut etc.

We would be happy to send you these installation instructions in your desired language.

Specification and installation instructions for attachment eye

Contact Person

NEWS

Premium-Partner